-------------------------------------------------------------------------- Setup hints for using BGFAX, PC Board 15.22, Class 1 fax modems 07-14-95 B.J. Guillot bgfax@blkbox.com FidoNet 1:106/400 http://www.blkbox.com/~bgfax/ -------------------------------------------------------------------------- If you are using a US Robotics modem, please see "PCB-USR.TXT" instead. If you are using a Class 2 fax modem, please see "PCB1522.TXT" instead. Please make sure the following two items are true before proceeding... (1) Your modem is NOT set to "Auto Answer" mode (REGISTER S0 MUST EQUAL 0) (2) You have already put all relevant DATA commands for the BBS into NVRAM Note that, generally, fax (AT+F) commands CANNOT be stored in NVRAM. Run PCBSETUP.EXE and make the following changes in the modem section... (Do not use PCBMODEM.) Make the following changes... Init-1 ATHZ Init-2 AT+FCLASS=1^M~~AT+FAE=1 Offhook ATH1M0 Answer ATA Dialout AT+FCLASS=0;DT If your BOARD.BAT file (or, whatever the file is that starts up your BBS), after the PCB.EXE line... pcb.exe if errorlevel 7 rcvfax.bat (If you have any other "if errorlevel" lines in your BOARD.BAT, remember that errorlevel numbers must be in DESCENDING order: 9,8,7,6,5, etc.) Make a new file called RCVFAX.BAT that says the following: @echo off bgfax /fhay:713_555_1212 c:\bgfax 1 z board.bat The "1" is for COM1. The "713_555_1212" will be replaced by your BBS tele- phone number. (Use underscores in place of spaces or dashes.) If this fails to work, try using a /FAX: parameter instead of a /FHAY: parameter. If you are using PC Board/2 and BGFAX/2 (OS/2 executables), instead of the "1" for COM1, you might need "H%pcbhandle%" or "V1" depending upon what version of PC Board/2 you are using. The "H" tells BGFAX that instead of a port number, a port handle follows. The "V" tells BGFAX to open the port followed by the "V" in VBBS-compatability mode, which is needed on some of the newer versions of PC Board/2. Example: bgfax2 /fhay:713_555_1212 c:\bgfax v1 z Regards, bgfax author